We were invited to the attic of a newly built family house. Insulation Mor. We measured a floor of 150 m2 with the owner, who wanted to use the attic for storage, so he chose walkable closed-cell polyurethane. We made the 10 cm insulation in a single day, a
Basically, more than half of the heat loss of properties leaves through the floor. The insulation of slabs and subfloors is therefore extremely important. Purfoam promises indisputable advantages over thermal insulation boards. It provides perfect, gap-free heat and water insulation where it would be difficult to insulate with other materials. It is an unbeatable solution even if you want to insulate on non-flat floors or along curved walls, around stairs and pipes. Thanks to the vapor-diffusive properties of polyurethane foam, the attic remains breathable even after the slab has been insulated, thus preventing mold and mildew.
On the roof or slab? Closed or open cell?
If the attic is not inhabited and there are no plans to install it, then the attic floor is insulated instead of the roof plane. The insulation of the slab is more efficient, since the heat flowing upwards is not allowed to reach the roof. On the other hand, the construction is also cheaper, since in the case of a high roof, the surface of the slab is smaller than that of the roof planes. If it is important that the insulation of the attic is walkable and load-bearing, we usually recommend mainly closed-cell foam. If the attic is not used at all, open-cell foam can also be considered. This foam is cheaper, but provides poorer thermal insulation, or not waterproof!
Insulation Mor. Attic slab thermal insulation
General benefits of SPF
We can cut heating costs in half! Heat, water and sound insulation in a single work phase, with one layer.
It provides a continuous, waterproof layer. Due to its vapor diffusion property, the house remains breathable.
A completely gap-free solution, therefore a perfect sealing layer, perfect for pipes, curved walls, etc.
100% waterproofing, excellent thermal insulation. It allows moisture to pass through to a certain extent, so your house remains breathable.
You do not have to dismantle and transport the old insulation. Fast and clean execution. It can even be cleaned with a high pressure washer.
Loadable, high compressive strength, gap- and gap-free insulation.
the customer was satisfied with the boys' work.
More attic insulation here: link